Sheet Metal BasicsForum for those beginning sheet metal layout and other related fields. Let the industry help answer your questions. There's plenty of experienced help in our shop wanting to help you.
The other day I was checking out a post about Take offs. This fitting would be an excellent one to install a splitter damper, so you could adjust the air more one way then the other if necessary. dupree
U never slow down U never grow old!! Keep up the GOOD work. 8--- 4--- 8 and out the gate!! code of excellence!
The hand flanger (easy edger) will do the job, but there's a point where the metal will hit the machine (about 2 inches from the inner 'v').
So, the last couple of inches have to be formed by hand.
Patience is a virtue.
The Following User Says Thank You to Rob For This Useful Post:
splitter's
dupree
Linear Mode
