| The time now is Nov 19, 2008 - 04:39 AM |
Are you registered?
Please register today and join some of the sheet metal industries best!
|
 |
 |
|
|
| Author |
Message |
|
|
Post subject:Electrical Diagrams
 Posted: Nov 26, 2006 - 08:04 PM #5548
|
|
Tinner
Joined: Nov 17, 2005
Posts: 27
Location: Canada
|
|
This isn't on air flow but deffinatly on th hvac side of things.
I'm trying to locate a wirring diagram showing how to connect a fan control, to an older powerpile gas valved furnace. I know it requires 24 volt transformer, and a relay, to control the heating cycle through stat.
A/C just hooks at fan control. My furnace i just pulled out was set up, but didn't pay attention when i ripped it out. Now i have the chore of wiring one up.
Till then...
Al. |
|
|
| |
|
|
|
 |
|
|
|
Post subject:RE: Electrical Diagrams
Posted: Nov 26, 2006 - 10:27 PM #5551
|
|
Moderator
Joined: May 13, 2003
Posts: 1354
Location: Waukesha
|
|
Hey Al, try this link...hope it helps you.
pdf_manual/Honeywell.pdf |
_________________
"If you make your job important it is quite likely to return the favor" Author Unknown
|
| |
|
|
|
|
|
|
|
Post subject:RE: Electrical Diagrams
Posted: Jan 16, 2007 - 11:24 PM #5801
|
|
Tinner
Joined: Nov 17, 2005
Posts: 27
Location: Canada
|
|
Loads of interesting info there, but not what i was looking for after a skim through. Have to take a closer look. All the examples that i seen only detail a heating cycle. Have to scratch my head and see if one is adaptable. Do you remeber that MacGyver show.... lol
till then... |
|
|
| |
|
|
|
|
|
|
|
All times are GMT - 6 Hours
|
|
|
|
|
|
|
FAQ
Search
Register
Log in to check your private messages
Log in
