The Sheet Metal Shop .Com

Duct Construction and Uses - turning vanes

blackaje - Feb 01, 2007 - 06:47 PM
Post subject: turning vanes

Thanks for the assistance on this forum. Based on a previous question that I submitted concerning the "T" intersection of heating ducts I understand that I need to have turning vanes installed. Would someone be so kind as to point me to picture of a turning vane and also to someone that sells.

Thanks again for the assistance and advice.

danski0224 - Feb 01, 2007 - 08:54 PM
Post subject:

Here ya go:

http://www.durodynecanada.ca/canada/pro ... e_rail.htm

If you only need a little bit, then you might want to have a local shop fab it for you, instead of buying a whole box of vane rail.

blackaje - Feb 01, 2007 - 11:42 PM
Post subject:

Thanks for the reply. The site depicts a 90 degree angle. I have literally a "T" split one to the left and the other to the right. Not sure how the vanes would be positioned.

Thanks

pricer - Feb 02, 2007 - 12:22 AM
Post subject:

Here is a drawing, top view, hope this helps.